Engine/carb help
4 posters
Page 1 of 1
Engine/carb help
My truck has set a while. I have drained all gas. Replaced filters and fluids. It idles well, but when you ease down on throttle it bogs. Then when the throttle is on the floor it bogs, gains no rpm. Do I need to remove carb? Or run treatment through gas line? HELP!!!! Please?
bigboyzcustumz- Member
- Posts : 15
Join date : 2015-05-07
Re: Engine/carb help
I do not know for sure. I am fairly versed on autos and motorcycles but it has me stumped
bigboyzcustumz- Member
- Posts : 15
Join date : 2015-05-07
Re: Engine/carb help
Auto's were all EFI till they swopped to carbs in '96 but it was optional on the manual.
PFM- Jet Addict
- Posts : 1901
Join date : 2010-04-24
Age : 63
Location : East Sussex
Re: Engine/carb help
I would just spray some carb cleaner in the intake first just in case a few things are sticking from being sat around. Mini's (SU carbs) would get sticky needles if left for a good while. Without hearing the problem it is difficult to diagnose the issue from afar, The other problems could be spark plugs, dizzy, ignition pack, blocked air intake? Can you post a vid?
Swarfing- Centurion
- Posts : 145
Join date : 2015-03-26
Location : Swindon
Re: Engine/carb help
When I get a chance. Atill learning the site also. Been trying the carb cleaner, it has a snorkel and Inremoved it and the air box and cleaned them. No blockages. Thought about plugs last night.
bigboyzcustumz- Member
- Posts : 15
Join date : 2015-05-07
Re: Engine/carb help
Give all the electrical bits spark plugs, distributor etc a clean first, dizyt cap could be furred up on the contacts? rotary arm dirty? HT leads breaking down? Is water flowing around the inlet manifold? is the choke working properly?
Need to check all these things one by one so they can be eliminated. You also get a nicely serviced motor too boot
Need to check all these things one by one so they can be eliminated. You also get a nicely serviced motor too boot
Swarfing- Centurion
- Posts : 145
Join date : 2015-03-26
Location : Swindon
Re: Engine/carb help
Done all that except plugs and cap and rotor. Plus traced the million miles of vacuum hose.
bigboyzcustumz- Member
- Posts : 15
Join date : 2015-05-07
Re: Engine/carb help
Will probably get spark plugs today. What is a good brand to use for this type of vehicle.
bigboyzcustumz- Member
- Posts : 15
Join date : 2015-05-07
Re: Engine/carb help
Electricity cares not so would just get the best you can afford really.
Swarfing- Centurion
- Posts : 145
Join date : 2015-03-26
Location : Swindon
Re: Engine/carb help
Would not go mad on things like split detonation plugs etc, regular is good enough :-)
Swarfing- Centurion
- Posts : 145
Join date : 2015-03-26
Location : Swindon
Similar topics
» Compatability between 1.3 efi engine 2000 model and a doner 2004 engine.
» 993 Carb Swop
» backfire through carb
» Piaggio porter 1.0 carb bimetal vacuum switch
» Hijet carb needles
» 993 Carb Swop
» backfire through carb
» Piaggio porter 1.0 carb bimetal vacuum switch
» Hijet carb needles
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|