poxy bloomin' head gaskets
2 posters
Page 1 of 1
poxy bloomin' head gaskets
Just had to remove the cylinder head again after I only fitted it on Thursday evening (I can get it off in about half an hour) when fitted and poured water in, it poured out the back and there is a half inch ish section thats failed on the top side of the gasket. Clare has just emailed the supplier and we are waiting for a response.
Re: poxy bloomin' head gaskets
must admit, now i have done the head on mine, can easily do it again when it comes to it. at least i know it doenst cost too much as well.
mind you, how many times can you skim a head?
mind you, how many times can you skim a head?
leopard_pagan- Admin
- Posts : 1112
Join date : 2009-09-21
Re: poxy bloomin' head gaskets
that depends on how bad it is and if you want to get into valve to piston clearence measuring but generally there will be max amount before you start to bother the water jacket I've just finished putting the head on again and it was using a cb22 charade head gasket.
Similar topics
» Hijet 993 CB42 Changed head gasket and skimmed head, now engine knocks/rattles ?
» What do you think about this Head Gasket,head block cylinder etc???
» Drainage plug gaskets??
» Which aftermarket brands for gaskets, seals, belts
» engine bits
» What do you think about this Head Gasket,head block cylinder etc???
» Drainage plug gaskets??
» Which aftermarket brands for gaskets, seals, belts
» engine bits
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|