radiator panel bodge!
4 posters
Page 1 of 1
radiator panel bodge!
here ya go... Velcro does the job...
Last edited by leopard_pagan on Thu Jun 24, 2010 6:53 am; edited 2 times in total
leopard_pagan- Admin
- Posts : 1112
Join date : 2009-09-21
Re: radiator panel bodge!
i have sticky back Velcro at work, may nab a bit and see if that works!
leopard_pagan- Admin
- Posts : 1112
Join date : 2009-09-21
Re: radiator panel bodge!
Is there anything you could cable tie it to?
kentgpz11- Centurion
- Posts : 295
Join date : 2010-02-11
Age : 57
Location : Stoke-On-Trent
Re: radiator panel bodge!
I have to say, I cant think what your on about :S
I cant say I have seen any orange knobs on my van!
I cant say I have seen any orange knobs on my van!
difflock123- Centurion
- Posts : 301
Join date : 2010-06-11
Re: radiator panel bodge!
the "bonnet" on a one litre van has two orange clips in the footwell behind the carpet where as the 1300 is mounted totally different fitting.
Re: radiator panel bodge!
well after yesterday, i doubt mine will have orange knobs!
cable ties will be hard to do up/cut. i know the velcro will work as i use it on other things and it sticks like shit to a blanket!
cable ties will be hard to do up/cut. i know the velcro will work as i use it on other things and it sticks like shit to a blanket!
leopard_pagan- Admin
- Posts : 1112
Join date : 2009-09-21
Re: radiator panel bodge!
Ours has no clips either, it's held in by gravity.
kentgpz11- Centurion
- Posts : 295
Join date : 2010-02-11
Age : 57
Location : Stoke-On-Trent
Re: radiator panel bodge!
mine is a 1L :S
then again, the panel on the front of my van has 2 hex or torx screw heads :S (the one between the headlights)
maybe the mounts on mine were broken
then again, the panel on the front of my van has 2 hex or torx screw heads :S (the one between the headlights)
maybe the mounts on mine were broken
difflock123- Centurion
- Posts : 301
Join date : 2010-06-11
Re: radiator panel bodge!
ahhhh.. done! and... as you go forward the force (yes Luke, your father drives a Hijet!) will push against it :0)
i tend to use this stuff a lot. will be used on the bike to fit the HID ballasts in to the nose cone.
i tend to use this stuff a lot. will be used on the bike to fit the HID ballasts in to the nose cone.
leopard_pagan- Admin
- Posts : 1112
Join date : 2009-09-21
Similar topics
» How do I remove front panel to access radiator cap?
» Terminal block - factory fit or an earlier bodge?
» mpv / bus 1.3 verse 1.0 panel van !
» panel lights
» WTB: 1.3l Hijet Panel Van
» Terminal block - factory fit or an earlier bodge?
» mpv / bus 1.3 verse 1.0 panel van !
» panel lights
» WTB: 1.3l Hijet Panel Van
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum