headlights. sealed beam units on my 993cc 1996
3 posters
Page 1 of 1
headlights. sealed beam units on my 993cc 1996
hi, have not been on the site for some time need help again please
been working on the old girl for some time i think she,s nearly ready for her mot
i recently as today replaced my rusty old beams with two new one,s as you can apprecate these have been on the van since 1996 ....
the three screws with washers and springs were all corroded with a bit of force the unit came away by depressing the unit and moving to one side
now i need to reset the lights for the mot,has anybody in the past set the lights up for thier mot
many thanks camperman:DÂ
been working on the old girl for some time i think she,s nearly ready for her mot
i recently as today replaced my rusty old beams with two new one,s as you can apprecate these have been on the van since 1996 ....
the three screws with washers and springs were all corroded with a bit of force the unit came away by depressing the unit and moving to one side
now i need to reset the lights for the mot,has anybody in the past set the lights up for thier mot
many thanks camperman:DÂ
camperman- Member
- Posts : 6
Join date : 2013-05-29
Re: headlights. sealed beam units on my 993cc 1996
Knock yourself out!!!
http://www.motuk.co.uk/manual_180.htm
Where what I do, it park I somewhere level pointing at a nice wall about 4 meters away.
I get them so they are pretty much straight level but pointing down a tad.
Then I make them point bang on straight then turn them to the kerb a tad.
Seems to work ok
http://www.motuk.co.uk/manual_180.htm
Where what I do, it park I somewhere level pointing at a nice wall about 4 meters away.
I get them so they are pretty much straight level but pointing down a tad.
Then I make them point bang on straight then turn them to the kerb a tad.
Seems to work ok
Re: headlights. sealed beam units on my 993cc 1996
cheers i,ll try that tomorrow will get bach to you thanks. just had alook at motuk wat a eye opener
tks very much.
tks very much.
camperman- Member
- Posts : 6
Join date : 2013-05-29
Re: headlights. sealed beam units on my 993cc 1996
It's a great site. Lets you know the goal posts for the annual nightmare!
Also from reading the handbook, you realise the MOT rules can be interpreted in different ways.
Also from reading the handbook, you realise the MOT rules can be interpreted in different ways.
Re: headlights. sealed beam units on my 993cc 1996
With regard to the setting of headlights , my old boss used to do a similar thing to H.J but he used a board to mark a cross on at the same height as the centre of the headlight and had someone hold it about 12 inches away from the headlight . He would then line the main beam up so that it would fall slightly below the horizontal line and in the centre of the vertical , and then dipped beam should fall in the bottom left hand corner of the cross .
Not done it myself but saw him do it many times on the trucks and he always came back with a pass .
Good Luck
Eddie
Not done it myself but saw him do it many times on the trucks and he always came back with a pass .
Good Luck
Eddie
Similar topics
» 1996 hIJET 993CC NEW ACCELERATOR CABLE
» Does a tow bar exist for the (1995-1996) 993cc blind van model?
» 1996 SE Hijet 993cc - no mot - sorned - needs petrol pump sorting
» Engine support beam size.
» hi jet camper units
» Does a tow bar exist for the (1995-1996) 993cc blind van model?
» 1996 SE Hijet 993cc - no mot - sorned - needs petrol pump sorting
» Engine support beam size.
» hi jet camper units
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|