Fuel sender fix
2 posters
Page 1 of 1
Fuel sender fix
Here is my slant on the fix for the fuel sender,
when I removed the sender the end cap was missing and but the float
was still in the tube because the tube was distorted.
I machined a 6mm thick delrin washer to fit the id of the tube with a 12mm bore with held the inner PCB central allowing the float to move freely.
It works but under braking when less than 1/3rd full the light flashes.
If I do it again i will make it a 12mm to hold the PCB but it needs a 1mm
or less hole so that the fuel drains out slowly.
when I removed the sender the end cap was missing and but the float
was still in the tube because the tube was distorted.
I machined a 6mm thick delrin washer to fit the id of the tube with a 12mm bore with held the inner PCB central allowing the float to move freely.
It works but under braking when less than 1/3rd full the light flashes.
If I do it again i will make it a 12mm to hold the PCB but it needs a 1mm
or less hole so that the fuel drains out slowly.
chaindrive- Member
- Posts : 14
Join date : 2018-12-29
Location : West Sussex
Re: Fuel sender fix
Excellent work
Raggy- Jet Addict
- Posts : 1630
Join date : 2015-05-25
Age : 60
Location : Doncaster
Similar topics
» Need a fuel gauge sender unit anyone have one for sale
» fuel sender
» Fuel Pump and Fuel Relay fine, Not priming on start up.
» hijet fuel tank sender
» Fuel sender for Hijet Pickup
» fuel sender
» Fuel Pump and Fuel Relay fine, Not priming on start up.
» hijet fuel tank sender
» Fuel sender for Hijet Pickup
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|