busy making tools

Recently I have been making up a carbon arc torch for my arc welder and than while I was there I got an old job out and did the write up on it that didn't hapen at the time.

http://www.instructables.com/id/Carbon-arc-torch/

http://www.instructables.com/id/Light-weight-rivnut-setter/

Me likey the rivnut tool.

Ingenious - might make mme one of them too!

And there is no reason you couldn't take a good pop riveter apart for the job and put it back to normal afterwards the yellow handle one was a crap pop rivet gun made of pressed tin the red one is cast alloy and a far better bit of kit but I had lost a part from the yellow one one of the time it had jammed so was going begging.