Manifold heat sheild & water pump
2 posters
Page 1 of 1
Manifold heat sheild & water pump
998 FEI 1997 MPV CB42
mine came off ok, but its rusted to hell, Sieve comes to mind!
anyone got one of these kicking about or know where i can get another in better condition?
BTW its the one that does not come in a head gasket kit.
Also after a water pump for the same van. not had a look at mine yet for condition but of its bad i'll be needing one!
seen a few on Flea bay but they all list the model before and after mine.
mine came off ok, but its rusted to hell, Sieve comes to mind!
anyone got one of these kicking about or know where i can get another in better condition?
BTW its the one that does not come in a head gasket kit.
Also after a water pump for the same van. not had a look at mine yet for condition but of its bad i'll be needing one!
seen a few on Flea bay but they all list the model before and after mine.
leopard_pagan- Admin
- Posts : 1112
Join date : 2009-09-21
Re: Manifold heat sheild & water pump
when I got the replacement pump for ours as soon as it came out the box I could see it was wrong and when they looked in to it they came up with a adaptor as the OE one has a 10mm bleed off spout but the replacement is smaller and you jam a 10mm spout into a bit of rubber hose to fit the pump and then connect in as usual. It has worked fine since fitting and the shop had sold one to someone before me and as far as they know its good too.
Similar topics
» WANTED water pump for washer on hijet 1 litre feb 1997 van
» water pump
» Exhaust Manifold
» Hijet 1.3 efi water pump replacement ?
» Manifold end of exaughst
» water pump
» Exhaust Manifold
» Hijet 1.3 efi water pump replacement ?
» Manifold end of exaughst
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|