Head Bolts
3 posters
Page 1 of 1
Head Bolts
My cylinder head is currently in the machine shop being pressure tested for any internal cracks after being found to be un-warped after the little drama n the hard sgoulder of the M3. Phew. But he did raise an eybrow when I told him that as far as I was aware, the engine doesn't use stretch bolts.
Rapid question:
The head bolts. Are they stretch bolts or regular?
Ta in advance.
Rapid question:
The head bolts. Are they stretch bolts or regular?
Ta in advance.
Eightpot- Centurion
- Posts : 102
Join date : 2014-07-09
Location : Grand Union, Paddington Arm
Re: Head Bolts
I always re use them, and I always skim the head as they warp in very funny ways I cant measure, but you can see it as its skimmed pass by pass.
Re: Head Bolts
Thanks for that. The primary cause of failure on my engine is increasingly looking like the head bolts were insufficiently torqued down followed by a dodgy jubilee clip on the thermostat housing. Need to look at the accuracy of my torque wwrench...
Interestingly, I did notice when putting a staight edge over the deck of the block, that the steel liners stood proud of the aluminium.
Interestingly, I did notice when putting a staight edge over the deck of the block, that the steel liners stood proud of the aluminium.
Eightpot- Centurion
- Posts : 102
Join date : 2014-07-09
Location : Grand Union, Paddington Arm
Re: Head Bolts
daihatsu didnt use strech bolts i heard from a friend of mine who has had several different daihatsu,s.
i know they didnt use them on my current car (hijet) and didnt on my previous (charade GTti).
i know they didnt use them on my current car (hijet) and didnt on my previous (charade GTti).
Guest- Guest
Similar topics
» What soket for cylinder head bolts for hijet s85 993cc motor?
» Hijet 993 CB42 Changed head gasket and skimmed head, now engine knocks/rattles ?
» What do you think about this Head Gasket,head block cylinder etc???
» Cylender Hed Bolts
» tips for removing head 998 MPV
» Hijet 993 CB42 Changed head gasket and skimmed head, now engine knocks/rattles ?
» What do you think about this Head Gasket,head block cylinder etc???
» Cylender Hed Bolts
» tips for removing head 998 MPV
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|